Rear View - Panasonic WJ-NV200K Installation Manual

Rear view

y Power cord inlet
y Power cord inlet [AC IN]
Connect the provided power cord to this inlet.
u Alarm/control connector [ALARM/CONTROL]
(D-sub 25-pin)
Connect a control switch to control the recorder using
an external device such as a sensor or a door switch or
an external alarm device such as a buzzer or a lamp.
i Network port [10/100/1000BASE-T]
Use this port to connect the recorder to a network com-
patible with 10BASE-T, 100BASE-TX or 1000BASE-T to
connect with a camera via a network. When the port is
being accessed, the access indicator (green) blinks.
When the port is being linked, the link indicator (orange)
lights.
o Spot output connector (BNC) [SPOT OUT]
Connect the live monitor. Camera images are output to
be displayed on a 1-screen.
How to use the power cord plug brace
Put the hooks of the power cord plug brace on the power
cord inlet to fix the power cord plug.
20
!2 HDD slots
!3 SIGNAL GND terminal
Power cord plug brace
Link indicator
Access indicator
u Alarm/control
connector
(D-sub 25-pin)
i Network port
!0 Audio output connector (RCA pin jack) [AUDIO
OUT]
Audio from live images or recorded images is output.
Connect such device as a speaker with amplifier.
!1 Monitor output connector (HDMI) [AV OUT]
This connector is used to connect to an HDMI-ready
monitor (the main monitor).
!2 HDD slots [HDD1/HDD2]
Hard disk drives (locally procured) can be installed into
these slots. Contact your dealer for installing/replacing
the hard disk drives.
!3 SIGNAL GND terminal [SIGNAL GND]
Connect this terminal with the SIGNAL GND terminals of
the devices in the system for signal ground. When oper-
ating the recorder and the devices in the system without
signal ground, oscillation or noise may be produced.
!1 Monitor output
connector (HDMI)
!0 Audio output connector
(RCA pin jack)
o Spot output connector (BNC)