Tool Assembly - Milwaukee 6514 series Operator's Manual

To reduce the risk of injury, always lock trigger
or remove battery pack before changing or
removing accessories. Only use accessories
specifically recommended for this tool.
Others may be hazardous.
Selecting a Blade
The Quik-Lok ® Blade Clamp can be used with all 1/2" shank universal
®
Sawzall blades. Use MILWAUKEE High Performance Super Sawzall
blades for best performance. When selecting a blade, choose the right
type and length.
Many types of blades are available for a variety of applications: cutting
metal, wood, nail-embedded wood, scroll cutting, roughing-in, and
contours.
Many lengths are also available. Choose a length long enough to extend
beyond the shoe and your work throughout the stroke. Do not use
blades less than 3-1/2" long since they will not extend beyond
the shoe throughout the stroke.
For best performance and longest life, see "Accessories" to select the
best blade for the job.

TOOL ASSEMBLY

WARNING!
Installing and Removing Blades
®
Quik-Lok Blade Clamp (Fig. 3)
Fig. 3
®
1. Remove battery pack.
2. Be sure the spindle and blade clamp areas are clean. Metal chips
and sawdust may prevent the Quik-Lok
securely (see "Maintenance").
3. To install a blade, twist the collar in the direction of the arrow while
inserting the blade into the clamp until the tang butts against the
collar.
Depending on the job, the blade may be inserted with the teeth
facing upward or downward.
4. Release the collar and the spring loaded mechanism will clamp the
blade firmly in place.
5. Twist the collar in the opposite direction of the arrow to ensure that
the blade is locked into the clamp.
6. Tug on blade to make sure it is securely locked in place.
7. To remove a blade, twist the collar in the direction of the arrow
while pulling on the blade. Be careful when handling hot blades.
Removing Broken Blades from the Quik-Lok
1. Remove battery pack.
2. Broken blades can be removed by the following methods.
• Point the tool downward, twist the collar, and shake the tool up and
down (DO NOT turn on the tool while your fingers are holding the
blade clamp open). The shank of the broken blade should drop out of
the clamp.
• If shaking the tool doesn't work...
In most cases, a corner of the broken blade will extend beyond the
blade clamp. Twist the collar and pull the broken blade out of the
clamp by this corner.
• If the broken stub doesn't extend far enough to be grabbed by its
corner, use a thin blade with small teeth (such as a metal cutting
blade) to hook the blade that is jammed in the clamp while twisting
the collar and pull it out.
Collar
Blade
® Blade Clamp from clamping
®
Blade Clamp
page 5