Headphones; Timer And Sleep Operation (Remote Control Only) - Pioneer X-HM30V-S Operating Instructions Manual

Timer and sleep operation (Remote
control only) (continued)
Checking the timer setting:
1 Turn the power on and press and hold down the
CLOCK/TIMER button.
2 Within 30 seconds, press the
"Once" or "Daily", and press the ENTER button.
3 Within 30 seconds, press the
"Timer Call", and press the ENTER button.
Cancelling the timer setting:
1 Turn the power on and press and hold down the CLOCK/
TIMER button.
2 Within 30 seconds, press the
"Once" or "Daily", and press the ENTER button.
3 Within 30 seconds, press the
"Timer Off", and press the ENTER button. Timer will be
cancelled (the setting will not be cancelled).
Reusing the memorised timer setting:
The timer setting will be memorised once it is entered. To
reuse the same setting, perform the following operations.
1 Turn the power on and press and hold down the CLOCK/
TIMER button.
2 Within 30 seconds, press the
"Once" or "Daily", and press the ENTER button.
3 Within 30 seconds, press the
"Timer On", and press the ENTER button.
4 Press the STANDBY/ON button to enter the power
stand-by mode.
n Sleep operation
The radio, disc, iPod, USB and Line In can all be turned off
automatically.
1 Play back the desired sound source.
2 Press the SLEEP button.
3 Within 5 seconds, press the Numeric button to set the
time (1 minute - 99 minutes)
4 "SLEEP" will appear.
5 The unit will enter the power stand-by mode
automatically after the preset time has elapsed.
To confirm the remaining sleep time:
1 Whilst "SLEEP" is indicated, press the SLEEP button.
or button to select
or button to select
or button to select
or button to select
or button to select
or button to select
En-41
To cancel the sleep operation:
Press the STANDBY/ON button whilst "SLEEP" is
indicated. To cancel the sleep operation without setting the
unit to the stand-by mode, proceed as follows.
1 Whilst "SLEEP" is indicated, press the SLEEP button.
2 Within 5 seconds, press the "0" button twice until
"SLEEP 00" appears.
n To use timer and sleep operation together
Sleep and timer playback:
For example, you can fall asleep listening to the radio and
wake up to CD in the next morning.
1 Set the sleep time (see above, steps 1 - 5).
2 Whilst the sleep timer is set, set the timer playback
(steps 2 - 9, page 40).
Timer playback
Sleep timer
setting
setting
1-99 minutes
Sleep operation will
automatically stop

Headphones

Do not turn the volume on to full at switch on and listen
l
to music at moderate levels. Excessive sound pressure
from earphones and headphones can cause hearing
loss.
Before plugging in or unplugging the headphone,
l
reduce the volume.
Be sure your headphone has a 3.5 mm diameter plug
l
and impedance between 16 and 50 ohms. The
recommended impedance is 32 ohms.
Plugging in the headphone disconnects the speakers
l
automatically. Adjust the volume using the VOLUME
control.
Audio from the iPod/iPhone cannot be heard via the
l
headphones connected to the unit. "HP INVALID" will
be displayed if you connect the headphones when the
iPod/iPhone function is selected.
End
time
Desired time
Timer playback
start time