Zone - Scantronic 9449 User Manual

? ? ? ?
2
#
ENTER
? ? ? ?
Interrupted Zone (x)
Exit Tone
? ? ? ?
Investigate cause and
restart setting sequence
Enter via Go to
designated control panel
route
? ? ? ?
1
TO FULL SET
Key-in your four digit user code (shown as ???? at
left). The exit tone starts. Leave premises via the
designated exit door. Exit tone stops after preset
time (or within seven seconds of pressing the exit
terminate button). Your alarm system is SET.
TO PART SET
Your alarm system may have been installed to allow
you to have part of the premises set while other
area(s) are off. To part set the system key in 2 then
ENTER, followed by your user code. Note that the
part set exit tone is usually a buzzer sound, but your
system may be programmed to silent set.
Note: If you enter your user code incorrectly four
times in a row then the system will raise a tamper
alarm. See opposite.
IF A ZONE LIGHT GLOWS WHILE SET-
TING
If, during setting, the sounder gives an interrupted
tone and a zone light glows, then a detector is being
triggered (maybe a door or window is open).
Key in your user code to stop the tone.
Check the indicated zone(s) and if possible correct
the cause of the alarm. Try setting the system
again. If the fault persists, call your alarm installer.
Note that it may be normal for certain zone lights to
glow as you walk past detectors on the way out of
your premises.
If the Entry/Exit light glows, the exit door may be
open. Leave the premises and close the door. The
interrupted tone should change to a steady tone
when the door is closed and the system then sets
as normal.
TO UNSET
Full Set: Enter by the designated entry door. Entry
tone starts. Go to control panel. Key-in your user
code. System is OFF.
Part Set: Entry tone starts. Go to control panel.
Key-in your user code. System is OFF.
Note: The system has a preset entry time to allow
you to get to the panel. If you find that you do not
have enough time to reach the control panel, ask
your Installer to increase the entry time.
496281 Issue 1