Stihl FSE 60 Instruction Manual page 39

6
2
5
N
Turn the spool (5) clockwise until
the two arrow heads line up –
secure the spool in this position.
N
Insert the cap (6) in the spool (5),
press it down as far as stop and turn
it clockwise at the same time.
N
Turn the cap (6) as far as stop and
tighten it down by hand.
FSE 60, FSE 71, FSE 81
Mounting STIHL AutoCut 5-2 Mowing
Head
Assembling the mowing head
4
2
1
3
N
Fit the spring (1) in the mowing
head (2).
The other steps are described in the
instruction sheet provided.
N
Wind the mowing lines (3) on to the
spool (4).
N
Thread the ends of the mowing
lines (3) through the sleeves and
place the spool (4) in the head.
Mounting the mowing head
6
3
N
Slip the mowing head (2) over the
shaft (5) and engage hex recess (7)
on the external hexagon (6).
N
Fit the cap (8) on the mowing head
– screw it clockwise on to the shaft
as far as stop and tighten it down
firmly.
Keep the instruction sheet for the
mowing head in a safe place.
Adjusting Nylon Line
STIHL AutoCut
N
Hold the rotating mowing head
above the ground – tap it on the
ground once – about 3 cm fresh line
is advanced.
English
8
2
7
5
37