Cycle Selection - GE GSD570 Use & Care Manual

operat
STEP 1. Load your dishwasher
with dishes, silverware, pots, pans,
bowls, etc. accordingto
instructions in the Loading section.
STEP 2. Add detergent to the
detergent dispenser. Make sure the
Cycle Indicator DiaI is at OFF
position before adding detergent.
(See Detergent Guide.)
Use rinse aid agent to help prevent
spotting. Occasionally check to
insure that rinse agent container is
at least half full. (See How To Use
A Rinse Agent.)
STEP 3. Select DRYING Option.
NO HEAT
DRYING
HEATED DRYING. Turns the
drying heater on for fast drying.
NO HEAT DRYING (energy
saving drying). Turns the drying
heater off to save energy. Dishes
will dry naturally over a longer
period such as overnight.
If you need your dishes sooner,
open the dishwasher door after the
cycle is complete to reduce the
natural drying time.
Use of this option reduces the
electrical energy used by this
model approximately
NORMAL WASH cycle.
e
STEP 4. Select the Cycle and start
dishwasher.
If your dishwasher drains into a
food waste disposer, operate the
disposer until it is empty before
starting the dishwasher. (See Cycle
selection hints on next page. )
To obtain the benefits of a
complete cycle, be careful that you
do not turn the dial any further
than necessary to start the
dishwasher.
a. Latch the door.
,.".
L
b. Slowly turn Cycle Indicator Dial
to ON position to start the cycle.
You will hear the motor start. There
is a time delay between start-up
and water fill so you wiIl not hear
any wash action right away.
for the
For WATER SAVER cycle:
a. Be sure door is unlatched.
b. Slowly turn Cycle Indicator Dial
to WATER SAVER position.
c. Latch door to start the cycle.
For RINSE & HOLD cycle:
a. Be sure door is unlatched.
WATER b. Select NO HEAT DRYING
drying option.
WASHING
c. Slowly turn Cycle Indicator Dial
to RINSE & HOLD position.
d. Latch door to start the cycle.
WATER SAVES
WASHING