Units - GE JHP68G Use And Care Manual

Plug-In Surface Units
Clean the area under the drip pans
often. Built-up soil, especially
grease, may catch fire. To make
cleaning easier, the plug-in surface
units are removable.
RECEPTACLE
MEDALLION
I
TERMINALS
I CHROME-PLATEO
SPIOER
ORIP P AN RING
/"
To remove:
s Be sure the control for the sur-
face unit is on OFF and the coils
are cool before removing the
Calrod@ unit.
Q Raise the unit coil opposite the
receptacle. Lift about one inch
above the trim ring and pull away
from the receptacle.
After removing the plug-in sur-
face unit, lift the drip pan/ring to
clean under the unit
To clean:
Wipe around the edges of the
surface unit opening in the range
top. Clean the area below. Rinse all
washed areas with a damp cloth or
sponge.
To replace:
c Place drip pan/ring in the surface
unit cavity found on top of the
range. Line up the drip pan so the
unit receptacle can be seen.
Insert the terminals of the plug-in
unit through the opening in the drip
pan/ring and into the receptacle.
Guide the surface unit into place
so it fits evenly and locks snugly
into the receptacle or trim ring.
Note: If your range has separate
trim rings, the drip pan must be
under the trim ring.
Do not attempt to clean, adjust, or
in any way repair the plug-in recep-
tacle. If liquid should spill and col-
lect inside the receptacle, call for
service.
Removable Oven Door
\
r-\ \
TO REMOVE door, open to BROIL
position, or where you feel hinge
catch slightly. Grasp door at sides;
lift door up and away from hinges.
TO REPLACE, grasp door at sides.
Line up door with hinges and push
door firmly into place.
42