Honda 08E91-E22-100B Installation Instructions Manual page 13

40. Wrap the vehicle 7-pin connector with one foam
cushion tape, then place the vehicle 7-pin
connector into the gap of the column.
VEHICLE 7-PIN
CONNECTOR
(brown)
(Squeeze into
this area.)
FOAM
CUSHION
TAPE
VEHICLE 7-PIN
CONNECTOR
41. Secure the engine starter harness to the vehicle
harness with four wire ties in the areas shown.
The lock of the wire ties should face up.
42. Remove the lower steering column support
bracket bolt. Attach the relay bracket to the
steering column support bracket and reinstall the
steering column support bracket bolt.
STEERING COLUMN
SUPPORT BRACKET
BOLT (Reuse.)
© 2007 American Honda Motor Co., Inc. - All Rights Reserved.
ENGINE STARTER
HARNESS
GREEN
TAPE
VEHICLE
LOCK
HARNESS
WIRE
TIE
ENGINE
STARTER
VEHICLE
HARNESS
HARNESS
VEHICLE
6D01111T
BRACKET
STEERING
COLUMN
SUPPORT
BRACKET
RELAY
BRACKET
43. At the right of the steering shaft, locate the sub
joint box. Using a small flat-tip screwdriver, unplug
the vehicle 6-pin connector from the sub joint box.
Plug the engine starter harness 6-pin connectors
into the vehicle 6-pin connector and the subjoint
box.
VIEWED FROM
UNDERSIDE
4 WIRE
TIES
FRONT
44. Attach the relay blocks and fuse case on the relay
bracket.
45. Secure the engine starter harness to the vehicle
harness using a wire tie.
6D01063T
AII 38215 (0710)
VEHICLE 6-PIN
CONNECTOR
SUB JOINT
BOX
ENGINE STARTER
HARNESS 6-PIN
VEHICLE 6-PIN
CONNECTOR
CONNECTOR
RELAY
BRACKET
FUSE
CASE
RELAY
BLOCK
ENGINE STARTER
HARNESS
6D01162T
VEHICLE
HARNESS
WIRE
TIE
6D01302T
13 of 21