Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Ovislink OV804WVA
Summary of Contents for Ovislink OV804WVA
- Page 1 OvisLink OV804WVA Quick Installation Guide...
-
Page 2: Indicators And Interfaces
Indicators and Interfaces Front Panel Color Status Description Power off. Green The initialization is normal. Power Initiating. Restoring factory defaults firmware Blinking upgrading. No signal detected. The device is handshaking with the physical Blinking Green layer of the office end. A connection is set up with the physical layer of the office end. -
Page 3: Rear Panel And Side Panel
Color Status Description 2.4G WLAN connection is normal. Data is transmitted through the 2.4G WLAN Blinking interface. No 5G WLAN connection. 5G WLAN connection is normal. 11AC Green Data is transmitted through the 5G WLAN Blinking interface. WPS negotiation enabled, waiting for the Blinking Green clients. -
Page 4: Hardware Connection
RJ-45 interface that connects to Ethernet uplink device or Ethernet wall jack through RJ-45 cable. Factory defaults resetting button. Keep power on, push a paper Reset clip into the hole, press and hold the button for 5-8 seconds, and then the system restores the default settings. USB2 USB port, for connecting USB storage devices. -
Page 5: Pc Network Configuration
Ethernet Uplink Connection Connect the LAN interface to your PC with an RJ-45 cable. Connect the WAN interface to the uplink network device with an RJ-45 cable. Plug one end of the power adapter to the wall outlet and the other end to the Power port of the device. -
Page 6: Obtain An Ip Address Automatically
Select Use the following IP address, set the IP address on the network segment of 192.168.1.x (x can be any number from 2 to 255), and then click OK to go back to the previous page. Obtain an IP address automatically Choose Start >... -
Page 7: Quick Configuration
For MAC OSX system Two methods are available to the wireless configuration. General Configuration Click icon on the upper left corner. Choose System Preferences. Click Network icon. Click the Status check box to turn Wi-Fi on, select the SSID from the wireless network list, and then click Apply.