Lighting The Stove - Primus Kinjia User Manual

3. Check the seals before connecting a new gas container to the appliance.
the appliance if it has damaged or worn seals.
4. The threads on both the gas cartridge and the regulator
damaged in any way or awry, replace the gas cartridge; or if the regulator is damaged, DO
NOT USE the stove. Order a new hose and regulator - see Accessories on the side flap.
5. Inspect the hose (so that it is neither kinked nor squashed. Avoid twisting the flexible
hose). Lift the pan support and drip tray
are properly adjusted.
PREPARE THE STOVE.
care to ensure that the stove is standing on a stable, flat surface with
no combustible material nearby. Check its stability! If you tip the stove
while there are pots on it, you risk being scalded by hot liquids.
1. Stand the stove on its side with the handle
and hose from the slot on the underside.
2.
Place the stove on a flat surface.
3. Open the lid on the stove by angling the handle 90°
pointing straight up, otherwise the lid cannot be opened. Lift the lid as far as it will go.
4.
In transportation mode, the pan support
the rough sides are uppermost, towards the pot. Ensure that the metal pins on the edges
sit in the holes in the drip tray .
Do not use
must be intact if they are
fto ensure that the hose and connector
important:
Take
uppermost. Remove the regulator
. It is important that the handle is
is upside down. Turn the pan support so that
5. Attach the gas cartridge to the regulator by screwing with a definite continuous motion
as far as it will go. Do this manually - DO NOT USE a pair of pliers, or similar.
6.
Make sure that the gas cartridge is level with the regulator upwards
gas is leaking from the connection between the regulator and the gas cartridge. Use
soapy water as discussed in the section "Before ignition" if you are unsure.

LIGHTING THE STOVE.

NO CIRCUMSTANCES MOVE the stove when it is lit, either with or
without pots. If, due to the wind, the flames are forced down under the
burner, turn the stove off and move it to a more sheltered location.
1. Rotate the gas supply knob for the burner
anti-clockwise, and light the burner with a long match, pocket lighter or similar.
2. Once the gas has been lit, you can adjust the flame and the supply of heat with the
supply knob. The gas should burn directly upwards with a steady flame.
3.
Put the pot or frying pan on the stove after the gas has been lit.
4. If you need to use two burners, light the second one the same way that you lit the first.
. Check that no
importanT:
UNDER
you want to light, about one turn