Lighting The Stove - Primus ONJA User Manual

2. The gas control knobs on the stove must be closed (turn clockwise to close) before
connecting the gas cartridge.
3.
Check the seals before connecting a new gas container to the appliance. Do not use
the appliance if it has damaged or worn seals.
4. The threads on both the gas cartridge and the valve
damaged in any way or awry, replace the gas cartridge - DO NOT USE the stove.
PREPARE THE STOVE.
care to ensure that the stove is standing with its legs fully folded out
on a stable, flat surface with no combustible material nearby. Check its
stability! If you tip the stove while there are pots on it, you risk being
scalded by hot liquids.
1.
Loosen the cutting board from the shoulder strap and remove it from the stove.
2. Fold out the gas supply knobs .
3. Stand the stove on its side and attach the gas cartridge
definite continuous motion as far as it will go. Do this manually.
4. Fold out the stove and place it on a flat surface.
5. Check that there are no gas leaks from the connection between the valve and the gas
cartridge. Use soapy water as discussed in the section "Before ignition" if you are unsure.
must be intact. If they are
importanT:
Take
by screwing it in with a

LIGHTING THE STOVE.

UNDER NO CIRCUMSTANCES MOVE the stove when it is lit, either
with or without pots. If, due to the wind, the flames are forced down
under the burner, turn the stove off and move it to a more sheltered
location.
1. Rotate the gas supply knob for the burner
anti-clockwise, and use an appropriate ignition device to light the gas.
2.
Once the gas has been lit, you can adjust the flame and the supply of heat with the
supply knob. The gas should burn directly upwards with a steady flame.
3. Put the pot or frying pan on the stove after the gas has been lit.
4.
If you need to use two burners, light the second one the same way that you lit the first.
importanT:
you want to light, about one turn