Installing The Card; Removing The Card - NEC Quadro K5200 User Manual

2.2 Installing the Card

(1) After making sure that workstation and peripheral devices are turned off, unplug the power
cord of the workstation.
(2) Remove the top cover from the chassis according to the User's Guide of the workstation.
(3) Remove the slot cover (fixing screw or fixing jig) from the PCI-Express (x16) slot, and remove
the slot cover or PCI-Express card.
※The PCI-Express slot of workstation may have card locking mechanism in addition to fixing
screw/fixing jig.
※Pay strict attention to remove the double-width card because the locking mechanism cannot
be seen directly. Applying excess power may cause damage to the lock lever.
Immediately after the workstation is turned off, its internal components and
PCI-EXPRESS card are extremely hot. Make sure that they are fully cooled down before

removing the card.

(4) Insert the PCI-Express card edge connector of Quadro K5200 into PCI-Express x16 slot on the
workstation so that the card can be connected firmly.
About retainer
If you want to connect a Quadro K5200 to 55Xa, connect into the workstation after you install
a retainer to QuadroK5200.(refer to the figure1-3.)
If you want to connect a 56Xg / 56Xg-E and 53Xi, attachment of the retainer to the Quadro
K5200 is unnecessary, because there is no fixed rail(see Figure 2) to the workstation.
Figure1
CAUTION
Pay attention to hot surface
Retainer
２０