NEC Quadro K5200 User Manual page 72

2.3 Removing the Card
※Before removing the card, make sure how to release the locking mechanism of PCI-Express slot
(see Figure 1).
※If you remove the card with the PCI-Express slot being locked, the locking mechanism may be
damaged.
(1) After making sure that workstation and peripheral devices are turned off, unplug the power
cord of workstation.
(2) Disconnect the monitor from workstation.
(3) Remove the top cover from workstation according to the User's Guide of workstation.
(4) Disconnect PCI-Express external power cable from PCI-Express external power connector on
Quadro K5200.
(5) Remove the screw or fixing jig from rear bracket of Quadro K5200.
(6) Remove the Quadro K5200 from PCI-Express slot while pushing the locking part (see Figure
1) toward the direction of arrow mark.
Note）Pull the Quadro K5200 straight up while pushing the locking part (see Figure 1) to unlock
the retainer and fixing rail so that the Quadro K5200 can keep parallelism, and then
remove the card from PCI-Express slot by the 55Xa.
Locking part
(7) Install the back slot cover to PCI-Express(x16) slot, and secure it with the screw or fixing
jig.
(8) Install the top cover of workstation.
Figure 1
Figure 3
[55Xa]
Retainer of Quadro K5200 and
fixing rail of workstation
２５
Figure 2