Dualtools PS7000 Owner's Manual page 17

POLISHING
For best results, always operate the polisher at low speed. Hold the polisher
firmly, allowing it to operate freely without unnecessary pressure. This tool was
designed so that the weight of the tool alone will provide adequate pressure for
polishing at top efficiency.
T o p o l i s h :
1. Hold the PS7000 in front and away from you, keeping it clear of the work area.
2. Press the switch trigger to start the polisher. Adjust the polishing speed to the
desired rate using the speed control dial.
3. Gradually lower the PS7000 against the work surface.
4. Polish with a long sweeping motion, back and forth.
Do not hold the polisher in one spot or use a circular or spiral pattern.
Always start polishing at the top or highest point and work down. This will prevent
light dust or polish film from being thrown upon a completed section. Also, it
eliminates pulling the tool's power cord over sections already polished.
Surfaces that have an old film of wax or polish, or that have not been polished or
waxed for an extended period of time, may require a second application. This is
especially true on oxidized surfaces. Heavily oxidized surfaces should be cleaned
with a commercial paste or liquid cleaner before polishing or waxing.
OPERATION
16