Table of Contents
Advertisement
Technical data
GB
Dimensions
Capacity
Water supply pressure
Power supply voltage
Total absorbed power
Fuse
6
width 59,5 cm
height 82 cm
depth 57 cm
14 standard place-settings
0,05 ÷ 1MPa (0.5 ÷ 10 bar)
7,25 psi – 145 psi
See appliance data plate
See appliance data plate
See appliance data plate
This dishwasher conforms to the
following European Community
Directives:
-2006/95/EC (Low Voltage)
-2004/108/EC (Electromagnetic
Compatibility)
-2009/125/EC (Comm. Reg.
1016/2010) (Ecodesign)
-97/17/EC (Labelling)
-2012/19/ CE Waste Electrical
and Electronic Equipment (WEEE)
Transportation
Unload all crockery from the dishwasher and secure moving
parts.
All water remaining inside the appliance should be drained
as follows:
make sure that the water tap is open and select the ECO cycle.
The cycle will begin. After 5 minutes, end the cycle by pressing
the ON/OFF button until you hear a beep and the indicator lights
switch off. Wait for approximately 5 minutes before uninstalling
the appliance. Shut off the tap and disconnect the inlet and
drain hose.
The appliance should only be moved in an upright position, in
order to prevent any water remaining inside the appliance from
damaging dishwasher components.
Leaving the machine unused for extended periods/
Freezing protection
If the appliance is situated in a location which is at risk of freezing,
or if you intend to be away for extended periods of time (e.g.
holiday home) , empty the appliance completely.
- Carry out the process used to drain all water remaining inside
the appliance (see Transportation).
- Disconnect the appliance from the electricity supply and shut
off the water tap.
- Leave the appliance door ajar.
- When you return, run a cycle while the dishwasher is empty.
Advertisement
Table of Contents
