English - Bosch GGW 10 E Operating Instructions Manual

3 609 929 306.book Seite 10 Mittwoch, 8. November 2006 8:45 08
Tool Specifications
Tapper
Article number
Rated power input [W]
Output power [W]
Rated speed
- Right rotation [rpm] 0 – 350
- Left rotation [rpm] 0 – 600
No-load speed
- Right rotation [rpm] 0 – 580
- Left rotation [rpm] 0 – 1 000
Cutting capacity for
threads
Tightening of stud bolts
Weight according to
EPTA-Procedure
01/2003 [kg]
Protection class
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
The values given are valid for nominal voltages [U] of 230/
240 V. For lower voltages and models for specific coun-
tries, these values can vary.
Noise/Vibration Information
Measured values determined according to
EN 60 745.
Typically the A-weighted sound pressure level of
the machine is 82 dB (A). Measurement uncer-
tainty K=3 dB.
When working, the noise level can exceed
85 dB (A).
Wear hearing protection!
The typical hand/arm vibration is below 2.5 m/s
The vibration emission level
WARNING
given in this information sheet
has been measured in accordance with a stand-
ardised test given in EN 60745 and may be used
to compare one tool with another.
The vibration emission level will vary because of
the ways in which a power tool can be used and
may increase above the level given in this infor-
mation sheet. This could lead to a significant un-
derestimate of exposure when the tool is used
regularly in such a way.
NOTE: To be accurate, an estimation of the level
of exposure to vibration experienced during a
given period of work should also take into ac-
count the times when the tool is switched off and
when it is running but not actually doing the job.
This may significantly reduce the exposure level
over the total working period.

10 | English

Declaration of Conformity
We declare under our sole responsibility that this
GGW 10 E
product is in conformity with the following stand-
PROFESSIONAL
ards or standardization documents: EN 60 745
0 601 462 8..
according to the provisions of the directives
500
89/336/EEC, 98/37/EC.
270
Dr. Egbert Schneider
Senior Vice President
Engineering
21.08.2006, Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
M 4 – M 10
Product Features
M 4 – M 12
The numbering of the product features refers to
the illustration of the machine on the graphics
2.7
page.
/ II
While reading the operating instructions, unfold
the graphics page for the machine and leave it
open.
1 Two-jaw chuck*
2 Hexagon nut
3 Lock-on button for On/Off switch
4 Thumbwheel for speed preselection
5 On/Off switch
6 Wing bolt for depth stop adjustment *
7 Wing bolt for auxiliary handle adjustment *
8 Auxiliary handle*
9 Depth stop*
10 Chuck key for two jaw chuck*
11 Stud-bolt chuck*
2
.
12 Rapid-change chuck*
13 Roller clutch*
14 Adapter for roller clutch*
15 Wedge*
* Illustrated or described accessories are not included
as standard delivery.
Intended Use
The machine is intended to cut threads in through
holes and with the respective accessory in blind
holes.
Dr. Eckerhard Strötgen
Head of Product
Certification
3 609 929 306 • 8.11.06