JVC LT-42DP8BG Instruction Manual page 63

Problem
Not displayed
(black screen)
Remote control stops
working
Digital channel screen
is frozen
Aspect ratio changes
unintentionally
PC screen alignment is
off
Enters "100Hz Clear
Motion Drive"
demonstration when
watching TV.
Poor picture quality
Strange picture when
using an external
device
Poor sound
No sound from the
audio component
Actions
Is the analogue channel reception poor, too?
Following the instructions in "Severe noise or snow" can
g
solve this problem.
Digital channels are not displayed
When the TV cannot find the digital channels
g
There may be problems at the aerial, radio waves, or the area
you live in, where reception is bad.
Consult your retailer.
Unplug TV, several minutes later plug it in again.
TV/AV MENU/OK
Hold down " " and "
three or more seconds to restart.
Press " " to return to your settings.
Adjust the "PC Position".
Set "Auto Demonstration" to "Off".
Change the "Picture Mode" setting.
Unnatural colour >>> Adjust "Colour" and "Bright-1".
Check your "Colour System".
Noise >>> Set to the following functions.
Picture Mode: Standard
Super DigiPure: Max
Dull picture >>> Set to the following functions.
Picture Mode: Bright
Super DigiPure: Min
If you connected S-Video output device, check the "S-In" setting.
If the top of the image is distorted, check the video signal quality
itself.
If movement appears unnatural when receiving a signal from a
DVD player etc., with 625p (progressive-scanning), change the
output setting of the external device to 625i (interlace-scanning).
Adjust the "MaxxAudio" setting.
If receiving a poor signal in "Stereo/ t·u", switch to "v"
(monaural).
Change the broadcasting system using "Manual".
Audio signals received from EXT-5 and EXT-6 cannot be sent
to the AUDIO OUT terminal.
" on the TV simultaneously for
Page
57
14
–
–
–
34
46
46
40
40
41
40
41
40
41
30
–
–
42
42
18
–
58