JVC LT-42DP8BG Instruction Manual page 58

Customising your TV
Setup (DTV)
Setup
Navigate
Digital Audio
Output
PCM : The Linear PCM signal is output
Dolby Digital : The Dolby digital signal is output when the Dolby Digital signal is received
Please read ""Dolby Digital" output from the DIGITAL AUDIO OUT terminal" (P. 62) before setting.
Banner Duration
Receiver Upgrade
The TV will automatically search for new tuner software and run the reception test (for digital
channels) at midnight (3AM) on a daily basis. You can select the desired operation with this
setting.
The Receiver Upgrade function works only when the TV is off (standby).
If new software is available, the TV will automatically download and upgrade the tuner software.
If the TV detects channels that became receivable or if the TV was not able to receive a certain channel,
a message about updating the PR List will be displayed when the TV is turned on.
"Updating the PR List" (P. 62)
g
Auto : The search for new software and the reception test will operate at midnight. In
Manual : Only the search for new software will operate at midnight. The reception test
53
14:00 05/05/2007
PCM
Digital Audio Output
2 sec
Banner Duration
Receiver Upgrade
No CI Module
Common Interface
Antenna Power
MENU
Select Exit
Output the digital signal from the DIGITAL AUDIO OUT terminal.
Select the display time for channel information
(2 sec / 5 sec / 8 sec)
addition, the TV will start searching for new software whenever the TV is
turned off. Normally set to "Auto".
will not be run. In addition, you can start searching for new software whenever
you want.
To start searching, select "Manual" and press "OK" button.
Software Version
2.14.03
OK Search for new
Select "Search for new" and press "OK" button. Then, follow the instructions
on the screen.
In standby: Upgrade the software automatically when the TV is turned off.
Auto
Off