General Information; Safety Information - Philips FW-V28 Service Manual

Video cd mini system
Hide thumbs Also See for FW-V28:
Table of Contents

Advertisement

CONTENTS

General Information ................. 5

Safety Information .................... 5

Preparation .......................... 6 - 7
Controls ............................... 8 - 10
Operating The System .... 10 - 12
CD - VCD ........................... 12 - 16
Tuner .................................. 17 - 18
Karaoke ..................................... 18
Tape ................................... 19 - 20
AUX ............................................ 20
Recording ......................... 21 - 22
Clock ......................................... 22
Timer .......................................... 23
Specifications ......................... 24
Maintenance ............................ 25
Troubleshooting .............. 25 - 26
PREPARATION
Rear Connections
L
C
6
2-1
GENERAL INFORMATION
IMPORTANT:
PLEASE NOTE THAT THE
VOLTAGE SELECTOR
LOCATED AT THE REAR OF
THIS SYSTEM IS PRESET AT
220V FROM THE FACTORY.
FOR COUNTRIES THAT
OPERATE AT 110V, PLEASE
ADJUST TO 110V BEFORE YOU
SWITCH ON THE SYSTEM.
General Information
• The type plate (which contains the
serial number) is located at the rear
of the system.
• Recording is permissible if
copyright or other rights of third
parties are not infringed.
Environmental Information
All unnecessary packaging has been
omitted. We have tried to make the
packaging easy to separate into three
materials: cardboard (box), polystyrene
foam (buffer) and polyethylene (bags,
protective foam sheet).
Your system consists of materials which
can be recycled and reused if disassembled
by a specialized company. Please observe
the local regulations regarding the disposal
of packaging materials, exhausted
batteries and old equipment.
B
FM AERIAL
+
R
L
+
R
AUX IN
D
AUDIO OUT
Accessories
(Supplied)
– Remote control
– Batteries (two AA size) for remote
control
– AM loop antenna
– FM wire antenna
– AC power cord
– One Video cinch cable
Safety Information
• Before operating the system, check that
the operating voltage indicated on the
typeplate (or the voltage indication
beside the voltage selector) of your
system is identical with the voltage of
your local power supply. If not, please
consult your dealer. The typeplate is
located at the rear of your system.
• When the system is switched on, do not
move it around.
• Place the system on a solid base (e.g. a
cabinet).
• Place the system in a location with
adequate ventilation to prevent internal
heat build-up in your system.
Allow at least 10 cm clearance from the
rear and the top of the unit and 5 cm
from each side.
• Do not expose the system to excessive
moisture, rain, sand or heat sources.
A
75Ω
AM ANTENNA
VOLTAGE
VOLTAGE
VOLTAGE
SELECTOR
SELECTOR
SELECTOR
220V-
110V-
110V-
240V
127V
127V
220V-
220V-
110V-
240V
240V
127V
AC
MAINS
~
VIDEO
OUT
E
SAFETY INFORMATION
• Under no circumstances should you
repair the system yourself, as this will
invalidate the warranty!
• If the system is brought directly from a
cold to a warm location, or is placed in a
very damp room, moisture may
condense on the lens of the disc unit
inside the system. Should this occur, the
disc player will not operate normally.
Leave the power on for about one hour
with no disc in the system until normal
playback is possible.
• Electrostatic discharge may cause
unexpected problems. See whether
these problems disappear if you unplug
the AC power cord and plug it in again
after a few seconds.
• To disconnect the system from the
power supply completely, remove
the AC power plug from the wall
socket.
F
G
PCS 103 727
5

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents