Installation; Electrical Connection; Changing The Opening Direction Of The Doors - Bosch KGS 36N00 Installation And Conversion Instructions

9000164038.qxd 06/03/06
EN
Before reading the instructions, turn to the
illustrations on the last page.

Installation

•
Install your combined freezer-refrigerator in
a dry, well ventilated room. In a damp room
the moisture in the air will form
condensation on the outside of the
appliance.
•
If the unit is placed next to a heat source
or another refrigerator, then the following
minimun lateral clearances must be
maintained (or an insulating panel used):
from electric cookers
from oil or coal-fired cookers
from other refrigerators
•
Since warm air generated at the back of
the refrigerator must be allowed to escape
unhindered, you must never block the
space between it and the wall nor cover
the ventilation grid at the base.
•
The appliance must stand firm and level.
To compensate for any uneveness in the
floor set the ajustable feet at the front,
fig Q. Two rollers underneath the appliance
allow it to be easily positioned in a niche.
•
Should the refrigerator be installed in such
a way that the fridge door opens onto a
side wall at right angles to it, a gap of 12
mm. should be left between the appliance
and this wall so that the drawers may be
withdrawn from the freezer compartment.

Electrical connection

•
The refrigerator must be connected to a
220-240 V AC (50Hz) supply only, and
must be protected by a 13 Amp fuse. The
connection must be made via a properly
installed socket with a non-fused earthing
contact.
Our contribution towards a cleaner
environment - we use recycled paper.
4
Downloaded from Fridge-Manual.com Manuals
13:35 Page 4
3 cm.
30 cm.
2 cm.
Changing the opening
direction of the doors
Before performing this operation, disconnect the
appliance from the mains electricity supply by
unplugging it or removing the fuse.
Unplug the appliance by pulling on the plug itself,
not the lead.
Fig. W
•
Lay the refrigerator on its back.
•
Lower hinge 4 unscrew the shaft on the
lower hinge 10 and fit it in the hole on the
left. Remove freezer door 3.
•
Unscrew central hinge 1 and remove
refrigerator compartment door 7
•
Remove plastic plugs 8 from the other side
(two parts) and press them into the holes
previously occupied by central hinge 1
•
Unscrew upper hinge pin 2 and screw it onto
the other side
•
Fit refrigerator compartment door 7 onto
upper hinge pin 2 and screw central hinge 1
into its new position. Do not forget to fit the
adjusting washers between refrigerator
compartment door 7 and central hinge 1
•
Remove covers and screws 11 and fit them
onto the other side.
•
Fit freezer compartment door 3 onto the
hinge pin of central hinge 1.
•
Screw lower hinge 4 into position.
•
When you have finished, set the fridge
freezer upright again.
•
Dismantle the plastic cover and remove the
screw that holds the handle in place 5. Slide
the handle 6 to the left and pull it out, as
shown in points 1-2 of Fig. W. Assemble the
handle on the other side by performing the
reserve of the operation just described.
Place the plastic cover in the hole that is left
after having changed the position of the
handle.
Important!
The fridge freezer should be left still for at
least two hours before turning it back on
again.