Table of Contents
Advertisement
OPTIONAL MOTOR ASSEMBLY KIT
INSTALLATION INSTRUCTIONS
STEP 1. REMOVE ACCESS DOOR PANEL LOCATED AT BOTTOM OF
UNIT.
BRACKET ALREADY ATTACHED TO THE MOTOR. ALIGN
THE HOLES IN MOTOR BRACKET WITH THE HOLES IN
MOTOR MOUNT. SECURE BRACKET WITH TWO 1/2" HEX
HEAD SCREWS PROVIDED.
STEP 2. REMOVE
RHEOSTAT INDICATING LABEL AND PLACE THE HOLE IN
CENTER OF LABEL TO LINE UP WITH HOLE IN THE RIGHT
SIDE HEARTH SUPPORT AS YOU FACE THE UNIT. PLACE
LABEL SO "OFF" POSITION IS AT THE 8 O'CLOCK
POSITION AND LOW IS AT THE 4 O'CLOCK POSITION.
MOUNT RHEOSTAT BY PLACING IT BEHIND HEARTH
SUPPORT WITH WIRES ON BOTTOM SIDE.
PLASTIC STUD THROUGH HOLE IN BRACKET AND
SECURE WITH RHEOSTAT MOUNTING NUT.
INDICATOR KNOB ON PLASTIC STUD.
STEP 3. REMOVE
SUPPORT AND DISCARD. MOUNT POWER CORD STRAIN
RELIEF HOLDER IN COVER MOUNTING HOLES. PLACE
THERMOSTAT
HEARTH TO THE RIGHT OF MOTOR. USE CABLE TIE TO
SECURE LOOSE WIRES.
STEP 4. REINSTALL ACCESS DOOR PANEL.
STEP 5. PLUG POWER CORD INTO SUPPLY OUTLET.
RHEOSTAT INDICATING KNOB IN DESIRED POSITION.
WHEN HEATER REACHES TEMPERATURE, FAN WILL
OPERATE AT DESIRED SPEED.
SECTION V
YOUR MOTOR ASSEMBLY COMES WITH A
THE
PROTECTIVE
STRAIN
RELIEF
BEHIND
Page 25
BACKING
COVER
FROM
"C"
CLIP
LOCATED
OFF
THE
PLACE
PLACE
HEARTH
UNDER
PLACE
Advertisement
Table of Contents
