Honda XL125L Manual page 89

Tyre Puncture
u
Installation
1. Attach the side collar and speedometer
gearbox to the front wheel.
2. Position the wheel between the fork legs
and insert the front axle shaft from the
right side, through the right fork leg and
wheel hub.
NOTICE
When installing the wheel, carefully fit the brake disc
between the pads to avoid scratching them.
Slot
Lug
86
Removing Wheels
3. Make sure that the lug on the right fork
leg is located in the slot of the
speedometer gearbox.
4. Tighten the front axle nut.
Torque: 44 N·m (4.5 kgf·m, 32 lbf·ft).
5. Install the rubber cap onto the front axle
nut.
6. After installing the wheel, apply the brake
lever several times and then check if the
wheel rotates freely. Recheck the wheel if
the brake drags or if the wheel does not
rotate freely.
7. Install the speedometer cable and tighten
the speedometer cable set screw securely.
If a torque wrench was not used for
installation, see your dealer as soon as
possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.