Appendix; Installing The Dust Filter (Optional Accessory) - Optoma w313 User Manual

Appendix

Installing the Dust Filter (Optional
accessory)
Be sure to follow the steps to install the dust filter.
1. Align the filter with these two hook positions (#1 & #2), then press it
close to the projector from the left side to the right one.
2. Press the last hook position (#3) until it clicks.
dust filter
3. Turn on the projector, then press "Menu", go to
OPTIONS > Optional Filter > Optional Filter Installed and
select "Yes".
4. Clean the dust filter periodically.
The dust filter should be used in dusty environments only. Filters
must be cleaned/replaced periodically i.e after every 500 hrs or 3
months, or sooner depending upon the air environment. Clogged
filter can restrict air flow causing the projector to heat excessively
leading to pre-mature lamp and/or projector failure.
5. To remove the dust filter, take it apart from the upper-left side of the hook
position.
6. Turn on the projector, then press "Menu", go
to OPTIONS > Optional Filter > Optional
Filter Installed and select "No" when you pull
out the dust filter and would not install it
again.
1
2
3
EN-47