Appendix; Installing The Dust Filter (Optional Accessory) - Optoma S310 Manual

Appendix

Installing the Dust Filter (Optional
accessory)
Be sure to follow the steps to install the dust filter.
1. Align the filter with the side of the projector.
2. Stick the filter to the ventilation holes until it hooked..
3. Turn on the projector, then press "Menu", go to
OPTIONS > Optional Filter > Optional Filter Installed and
select "Yes".
4. Clean the dust filter periodically.
The dust filter should be used in dusty environments only. Filters
must be cleaned/replaced periodically i.e after every 500 hrs or 3
months, or sooner depending upon the air environment. Clogged
filter can restrict air flow causing the projector to heat excessively
leading to pre-mature lamp and/or projector failure.
5. To remove the dust filter, take it apart from the projector.
6. Turn on the projector, then press "Menu", go
to OPTIONS > Optional Filter > Optional
Filter Installed and select "No" when you pull
out the dust filter and would not install it
again.
EN-50