Section Vii: Alcove Installation - New Buck Corporation 384 Owner's Manual

CAUTION: READ ENTIRE MANUAL BEFORE INSTALLING HEATER
(1) For clearances, see Figure below. The minimum must be met.
(2) For Installation and Gas Hookup Connection see page 5 .
CAUTION: The installation must conform with local codes, or in the absence of local codes,
with the National Fuel Gas Code, ANSI Z223.1/NFPA54.
WARNING: DO NOT USE THIS HEATER IF ANY PART HAS BEEN UN-
DER WATER. IMMEDIATELY CALL A QUALIFIED SERVICE TECHNI-
CIAN TO INSPECT THE ROOM HEATER AND TO REPLACE ANY PART
OF THE CONTROL SYSTEM AND GAS CONTROL WHICH HAS BEEN
UNDER WATER.
WARNING: IMPROPER INSTALLATION, ADJUSTMENT, ALTERATION,
SERVICE OR MAINTENANCE CAN CAUSE PROPERTY DAMAGE, PER-
SONAL INJURY OR LOSS OF LIFE. REFER TO THIS MANUAL.
WARNING: ANY CHANGE TO THIS HEATER OR ITS CONTROLS CAN
BE DANGEROUS."
*ALL DIMENSIONS ARE MINIMUM TO COMBUSTIBLE WALL
4"
LEFT
FRONT OF UNIT
WALL
SECTION VII
MODEL 384
ALCOVE INSTALLATION
REAR WALL
2"
4"
RIGHT
WALL
Page 30
CEILING
26"
2"
.