Select The Input; Input Naming - PS Audio DirectStream Junior Owner's Reference Manual

®

Select the Input

SELECT THE INPUT
The fi rst step is to select the input you wish to play. This can be accomplished with the remote control
or through the front panel selector and display.
Touch the selector button on the left side of the screen. The fi rst press will show the active display.
Touch again and you toggle to the next input.
Lock Light
Each input has a lock light associated with it. The lock light has two states: connected (displays an
asterisk in the upper right corner of the display) and not connected (nothing displayed). It is also
possible to select AUTO. AUTO input senses when a digital input is actively playing music and switches
to the live input. This is the recommended input setting.
Name the Input

INPUT NAMING

For greater convenience, it is possible to assign a custom name to each input, such as PWT, XLR, etc.
To name each input, you must fi rst enter the setup display. Select the input you wish to change. Once
selected, hold the selector button down for 3 seconds to enter the display mode. The fi rst screen is
balance. Press the selector button once again, while in the setup mode, to toggle to the input naming
screen. The input already selected will appear, along with data and bit rate information. Depress and
4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com
Getting Started
©2016 PS Audio Inc. All rights reserved.
Owner's Reference DirectStream Junior
Getting Started
15-073-01-1
Rev A 6