Screen Brightness - PS Audio DirectStream Junior Owner's Reference Manual

®
hold the selector button until the Name Edit Screen is displayed.
The cursor sits under the letter you can select. Rotate the volume knob to choose which letter you
desire. Press the selector button and that letter will appear as part of the name. Repeat the process
until you spell the input name. Press and hold the selector button to leave the naming edit screen.
Set the Output
DirectStream Junior has two output levels: High and Low. In the standard output mode, DirectStream
Level
Junior will provide adequate output level to directly feed a power amplifi er without use of a preamplifi er.
If the power amplifi er or preamplifi er is overly sensitive, or you need to reduce the output level of
DirectStream Junior for any reason, you can activate the output attenuator to reach a lower level.
There should be no sonic penalty for doing so.
To turn on/off the output attenuator, press the DAC Level button on the remote. Or, go to the setup
screen which is accessed by depressing the selector button, located to the left side of the display, for 3
seconds to enter the setup mode. Toggle through the setup screens with a button push. Once you get
to the Attenuator screen, use the volume control knob to select In (lowest gain) or Out (normal gain).

Screen Brightness

The unit's screen brightness can be adjusted in the setup menu as well. The display can be turned
4826 Sterling Drive, Boulder, CO 80301
PH: 720.406.8946 service@psaudio.com www.psaudio.com
Getting Started
©2016 PS Audio Inc. All rights reserved.
Owner's Reference DirectStream Junior
Getting Started
15-073-01-1
Rev A 7