Connecting To Other Equipment; Connecting To A Television - Casio QV-3000EX/Ir User Manual

USB Port Co

CONNECTING TO OTHER EQUIPMENT

Connecting to a Television

Images being displayed on the camera's monitor screen,
Computer
whether for recording or playback can also be displayed on USB port
the screen of a connected television.
Accessory
video cable
IMPORTANT!
TV
INPUT
L R
AUDIO
• Whenever connecting the USB cable to the camera,
make sure the arrow mark on the plug is aligned prop-
VIDEO IN terminal
erly with the arrow mark on the side of the camera's
terminal.
• Plug the USB connectors into the ports as far as they
1.
Connect one end of the video cable to the cam-
will go. Incorrect connection can result in improper op-
era and the other end to the television.
eration.
• The camera is not supplied power by the USB cable.
2.
Set up the television for video input.
Be sure to use the optional AC adaptor to power the
• See the documentation that comes with the television
camera whenever using a USB cable connection.
for information about how to do this.
• Never disconnect the USB cable while a data commu-
nication operation is in progress. Doing so can corrupt
3.
The connection procedure is the same for both
memory data.
recording and playback.
Downloaded From camera-usermanual.com Downloaded From camera-usermanual.com
CONNECT
CONNECTING TO OTHER EQUIPMENT CONNECTING TO OTHER EQUIPMENT
USB cable
Large
VIDEO
VIDEO OUT
terminal
IMPORTANT! • Connecting the camera to a computer with the USB
cable causes the "USb" to appear in the camera's indi-
Small • A television must have a video input terminal like the
cator display. This simply means that the cable is con-
one shown in the illustration to connect to this camera.
nected but does not mean that the camera is being
• Battery capacity (page E-30) and other displays that
recognized by the computer as an external storage
normally appear on the camera's monitor screen are
device. Perform the required operation on your com-
also displayed on the television screen.
puter to check whether the camera is being recog-
Selecting the Video Output Signal Mode
nized by the computer as an external storage device.
• USB data communication becomes enabled when-
You can select either of two common video output modes:
ever you connect the USB cable, regardless of
NTSC or PAL.
whether the camera is in the PLAY Mode or REC
The video system you should use depends on the country
Mode.
USB port
where you plan to use the output signal. In the United States
• Disconnect the USB cable after you are finished with
or Japan, for example, you should use NTSC, but in Europe
data communication.
you need to use PAL.
• You cannot turn off the camera while the USB cable is
Check with your local video or TV retailer if you are unsure
connected. Disconnect the USB cable first when you
about which video mode you should use in your country.
want to turn off the camera.
IMPORTANT!
Selecting PAL causes the monitor screen to go blank
Data Transfer Cable Connection
during video output.
You can use the Data Transfer Cable to connect to your per-
1.
Press MENU.
sonal computer through the camera's DIGITAL terminal.
Then you can save images on your computer's hard disk us-
2.
Select "Set Up"
ing the Photo Loader application.
• See the separate installation manual for information about
3.
Select the video mode you want to use.
how to install Photo Loader on your computer.
E-99
"Video Out".