Locating And Mounting - Petsafe prf-3004xw-20 Operation Manual

ENGLISH
Quick Start Guide for Installing Your System
The Standard Pet Containment System is simple and easy to use. Follow these
8 easy steps. Additional details can be found on the following pages.
1
Layout
Make a layout that is suitable for your yard. Refer to
sample layouts under "Laying Out Your System"
2

Locating and mounting

the Fence Transmitter
Mount the fence transmitter in a dry location. A
mounting template is located on the back cover of
this manual.
3
Layout the Boundary Wire
Lay the boundary wire above the ground according
to your layout. Insert stripped wire ends into wire
terminals of the transmitter.
4
Remove the Receiver Cover
from the Receiver
Using a Phillips head screwdriver, remove the four
screws from the back cover and take the cover off of
the receiver.
5
Insert the Battery into the Receiver
Once open, connect a 9-volt alkaline battery to the
battery connector. Place the connected battery into the
receiver and replace the back cover.
2
400-525-19 XW 2 9/24/03, 9:59 AM