Securing The Tv - Sony KLV-B20G10 Operating Instructions Manual

On cleaning the cabinet
• Be sure to unplug the AC power cord connected to the
LCD TV from the AC power outlet before cleaning.
• Clean the cabinet with the cleaning cloth or a soft cloth
lightly moistened with a mild detergent solution.
• Note that material deterioration or screen coating
degradation may occur if the display unit is exposed to a
volatile solvent, such as alcohol, thinner, benzine or
insecticide, or if prolonged contact is maintained with
rubber or vinyl materials.
On the screen
• Although the LCD screen is made with high-precision
technology and has effective pixels of 99.99% or more,
black dots may appear or bright points of light (red, blue
or green) may appear constantly on the LCD screen. This
is a structural property of the LCD panel and is not a
malfunction.
• Do not expose the LCD screen surface to the sun. Doing
so may damage the screen surface.
• Do not push or scratch the front filter, or place objects on
top of this unit. The image may be uneven or the LCD
panel may be damaged.
• If the unit is used in a cold place, a smear may occur in the
picture or the picture may become dark. This does not
indicate a failure. These phenomena improve as the
temperature rises.
• Ghosting may occur when still pictures are displayed
continuously. It may disappear after a few moments.
• The screen and cabinet get warm when this unit is in use.
This is not a malfunction.
Fluorescent lamp
• This unit uses a special fluorescent lamp as its light
source. If the screen image becomes dark, flickers, or does
not appear, the fluorescent lamp has run down and should
be replaced. For replacement, consult qualified service
personnel.
8
GB

Securing the TV

Preventing the TV from toppling over
B KLV-B20G10 only
Attaching the Support Belt
1
Screw the support belt (supplied) to the
TV stand with a wood screw (supplied).
2
Attach the support belt to the stand, and
screw the belt with a securing screw
(supplied) using a coin, etc.
3
Adjust the length by pulling the support
belt towards you while holding the TV
stand.
Notes
• Be sure to take measures to prevent the TV from toppling
over and causing injury.
• The supplied wood screw may not be used depending on
the type of TV stand. In this case, or when the securing
strength is not enough, prepare commercial screws to fit to
the TV stand. Use commercial screws of 3 to 4 mm
diameter. Consult your dealer about the types of screw.
2
3
1