General Information; Specifications - Woods 8000 Operator's Manual

The purpose of this manual is to assist you in oper-
ating and maintaining your chipper. Read it care-
fully. It furnishes information and instructions that
will help you achieve years of dependable perfor-
mance. These instructions have been compiled
from extensive field experience and engineering
data. Some information may be general in nature
due to unknown and varying operating conditions.
However, through experience and these instruc-
tions, you should be able to develop procedures
suitable to your particular situation.
Overall Size
Overall Weight
Maximum Chipper Capacity
Chipper Blade
Chipping Anvil
Disc Speed
Disc Size
Disc Weight
Discharge Tube Size
Discharge Tube Height
Drive Type
Drive Belt Size
Hydraulic Drive Belt Size
Spline Size
3-Point Hitch
PTO Speed
Hydraulic Feed Rate
Hydraulic Oil Tank Capacity
4 Introduction

GENERAL INFORMATION

SPECIFICATIONS

9-1/4" x 3-1/2" x 5/8"
3RB64.5 (67-1/2")
1-3/8" Diameter (6 - Spline)
The illustrations and data used in this manual were cur-
rent at the time of printing, but due to possible inline
production changes, your chipper may vary slightly in
detail. We reserve the right to redesign and change the
chipper as may be necessary without notification.
Throughout this manual, references are made to right
and left directions. These are determined by standing
behind the equipment facing the direction of forward
travel.
8000
45" x 47" x 90"
885 lbs.
8"
4
1500 RPM
30" Dia. x 1-1/4"
247 lbs.
32" x 36"
95"
Belt
1-3/8" Diameter (6 - Spline)
Category 1
540 RPM
8100
45" x 47" x 90"
885 lbs.
9"
4
9-1/4" x 3-1/2" x 5/8"
1500 RPM
30" Dia. x 1-1/4"
247 lbs.
32" x 36"
95"
Belt
3RB64.5 (67.5")
Bx44 (45.8")
Category 1
540 RPM
0 - 150 ft/min.
3 Gallon
51210 (1/1/2016)