Service 19 - Woods 8000 Operator's Manual

The information in this section is written for operators
who possess basic mechanical skills. If you need help,
your dealer has trained service technicians available.
For your protection, read and follow the safety informa-
tion in this manual.
 Before inspecting, servicing, storing, or chang-
ing an accessory, shut off power source, make
sure all moving parts have come to a complete
stop, and disconnect PTO driveline.
Component
Hydraulic Oil
All Internal and External Nuts
and Bolts
Chipper Anvil
Chipper Blades
Entire Machine
PTO U-Joints
PTO Inner Drive Tubes
PTO Shield Retainer Bearing
Drive Belt
Hydraulic Drive Belt
Belt Tension
Belt/Pulley Alignment
Grease Fittings
Hydraulic Oil Filter
(1) Perform More Frequently When Chipping Dry Or Dirty Wood.
51210 (1/1/2016)
SERVICE
ARNING
Service and Maintenance Schedule
Maintenance
Required
Check/Fill
Check Tightness
Check Clearance and
Retorque to 75 lbs/ft (1)
Check Sharpness and
Retorque to 120 lbs/ft (1)
Clean
Lubricate
Lubricate
Lubricate
Check
Check
Check
Check
Lubricate
Replace
Figure 1. Service and Maintenance Schedule
LUBRICATION
1. Do not let excess grease collect on or around
parts, particularly when operating in sandy areas.
2. Use a lithium grease of #2 consistency with a
MOLY (molybdenum disulfide) additive for all
locations unless otherwise noted.
NOTE: Be sure to clean fittings thoroughly before
attaching grease gun. One good pump of most
guns is sufficient when the lubrication schedule is
followed.
Frequency
Before Every 8 Every 25
Each Use Hours Hours
✔
✔
✔
✔
✔
✔
✔
✔

Service 19

Every 50 Every 200
Hours Hours
✔
✔
✔
✔
✔
✔