Woods 8000 Operator's Manual page 32

DP6
Figure 4. Model 8100 Chute Extension Assembly
6. Tighten the eight bolts holding the chute in place.
7. Connect the three wires coming from the feed
chute to the connectors
underneath the feed roller, matching the zip tie
colors.
ATTACH DISCHARGE TUBE
1. Attach one clamping ring (1) and one spacer ring
(2) to discharge tube base (3) using three 3/8 x 1-
1/4 bolts (4) and nylock nuts (5). Tighten leaving
1/16" gap to assist in mounting to flange. (See
Figure 5).
DP6
Figure 5. Discharge Tube Clamp Ring and Spacer
2. Slide the tube onto the mounting flange on the
chipper frame. The discharge clamp (1) should
32 Assembly
that are located
slide underneath the lip of the flange. Tighten the
bolts to secure.
3. Install the second half of the spacer (2) and clamp
ring (1) on the discharge tube with 3/8 x 1-1/4 bolts
(4) and nylock nuts (5).
Figure 6. Discharge Tube Assembly
NOTE: Keep nuts as tight as possible while
allowing the discharge tube to freely turn.
4. Lubricate the discharge tube by applying grease to
the grease fitting at the base of the tube. Rotate
the tube and apply grease until the tube rotates
freely.
5. Rotate the tube 360 degrees and lock it in place
with the lock pin to make sure it is mounted
correctly.
6. Attach the discharge deflector (6) to the discharge
tube. Connect the deflector with two 5/16 x 1-1/4
bolts (7) through the lower hole in the discharge
tube. Run these bolts through the inside of the
tube, washer, deflector, washer and then knob, (8).
7. Finish assembling the deflector to the tube with two
5/16 x 1 bolts (9) through the end hole in discharge
tube and secure with 5/16 washers and nylock nuts
(10).
Figure 7. Discharge Tube Deflector Assembly
51210 (1/1/2016)