Assembly 31; Assembly Instructions - Woods 8000 Operator's Manual

DEALER SET-UP INSTRUCTIONS
Assembly of this chipper is the responsibility of the
Woods dealer. If should be delivered to the owner
completely assembled, lubricated, and adjusted for
normal chipping conditions.
Remove chipper from shipping crate. Place unit on a
level surface before beginning assembly.
Assembly will be easier if parts are aligned and loosely
assembled before tightening hardware. Recommended
torque values for hardware are located in the Bolt
Torque Chart, page 63.
Complete check lists on page 34 when you have
completed the assembly.
ATTACH CHUTE - MODEL 8000
1. Mount the chipper chute to the frame mounting
bracket using eight 3/8 x 1-1/2 bolts and lock nuts.
Use three bolts on each side and two on the
bottom.
Figure 1. Model 8000 Chute Assembly
ATTACH CHUTE - MODEL 8100
1. Attach the chute support to the front side of the
chipper base with one 3/8 x 1 hex bolt, washer and
nut.
2. Attach the chipper chute to the feed roller with
eight 3/8 x 1-1/2 carriage bolts, washers and nuts.
Thread the bolts from inside the chute. Do not
tighten completely at this time.
3. Attach the chute support to the chute through the
middle hole on the extension tray hinge using
existing hardware.
51210 (1/1/2016)

ASSEMBLY INSTRUCTIONS

DP4
Figure 2. Model 8100 Chute Assembly
4. Tip the extension tray up and slide it over the
chipper chute. (See Figure 3). Make sure to
position the lip on the extension tray behind the lip
on the chipper chute.
Figure 3. Model 8100 Chute Extension Assembly
5. Insert five 3/8 x 1 carriage bolts through the five
outside holes on the extension tray and hinge.
Adjust so the tray can be locked in upright position
with the lock pin on the chute. Secure the bolts with
washers and nuts. (See Figure 4).

Assembly 31