Quick Easy Setup Connection Path - Netopia 3346-ENT Getting Started Manual

6-2 Getting Started Guide

Quick Easy Setup Connection Path

This section may be all you need to do to configure your Netopia 3346-ENT ADSL Router. Your service provider
will supply you with several parameter values. Below is a handy checklist:
Trellis Coding Enabled
Fast Retrain Enabled
Wiring Type
Data Link Encapsulation
Data Circuit VPI
Data Circuit VPI
Address Translation
Enabled:
IP Addressing:
(for PPP DLEs only)
PPP Authentication:
Ethernet IP Address:
Ethernet Subnet Mask:
Domain Name:
Primary Domain Name
Server:
Secondary Domain Name
Server:
Default IP Gateway:
Write Access Name:
DSL Line Configuration Screen
❑
On (default) or
❑
Off
❑
On (default) or
❑
Off
❑
Tip/Ring (Inner Pair) (default) or
❑
AutoSense
❑
A/A1 (Outer Pair)
❑
RFC1483 (default)
or
❑
PPP
0-255 (8 is default)
0-65535 (35 is default)
Easy Setup Profile Screen
❑
Yes (default) or
❑
No
❑
Numbered (default) or
❑
Unnumbered
❑
None (default),
❑
PAP or
❑
CHAP
IP Easy Setup Screen
_______________________
_______________________
_______________________
_______________________
_______________________
_______________________
Easy Setup Security Configuration Screen
_______________________
RFC1483 Mode:
❑
Bridged 1483 (default) or
❑
Routed 1483
PPP Mode:
❑
VC Multiplexed (default) or
❑
LLC SNAP
_______________________
_______________________
(for Numbered IP Addressing)
Local WAN IP Address:
_______________________
Local WAN IP Mask:
_______________________
(for PAP or CHAP)
User Name (or Host Name):
_______________________
(192.168.1.1
255.255.255.0
are defaults)
Write Access Password:
(for Bridged 1483 only)
PPP over Ethernet (PPPoE)
❑
Off (default) or
❑
On
(for Unnumbered IP Addressing)
Remote IP Address:
_______________________
Remote IP Mask:
_______________________
(for PAP or CHAP)
Password (or Secret):
_______________________
_______________________