Dometic MaCave S17G Operating Manual page 56

Troubleshooting
Problem
Appliance switches itself
on and off
The light does not work.
The appliance vibrates
The appliance seems to
make a lot of noise
The door does not close
properly
LED indicates E1, E2 or E7.
56
Possible cause
Room temperature is higher than
average.
The cabinet was recently replen-
ished with new bottles
Door was opened frequently
Door was not closed properly
Door is not hermetically-sealed
Appliance is not connected to a
power supply
Circuit breaker or fuse has blown Switch on circuit breaker or
The light was switched off on the
control panel.
The appliance is not properly
level
The noise is probably caused by the refrigerant, which is normal.
At the end of each cycle, you will hear noises made by the flow of
refrigerant.
If temperature fluctuations occur, the contraction and expansion
of the inner walls may cause popping and cracking noises.
The appliance is not properly
level
The appliance is not properly
level
The door hinge was changed
incorrectly
The door seal is dirty
The shelves are not fitted cor-
rectly
The temperature sensor for the
fan inside the appliance shows
an error
MaCave
Remedy
Put the appliance in a cooler
place
Leave the appliance to work
for a while until the set tem-
perature has been reached.
Do not open the door more
often than necessary
Close door properly
Check the door seal and
clean or replace
Connect the appliance
replace fuse
Switch on the light
Level the appliance with the
adjustable feet
Level the appliance with the
adjustable feet
Level the appliance with the
adjustable feet
Check the door hinge and
reassemble correctly
Clean the door seal
Check the shelves and refit
correctly
This can only be repaired by
an authorised repair centre.
EN