Bosch AQT 33-11 Original Instructions Manual page 7

OBJ_BUCH-2384-002.book Page 7 Wednesday, February 18, 2015 4:12 PM
Mounting and Operation
Action
Delivery Scope
Mounting cable bracket/in use storage for gun 2
Connecting/disconnecting high pressure
gun to lance
Connecting/disconnecting nozzle
Connecting/disconnecting high pressure
water supply hose/nozzle
Connecting to the water supply
Switching On and Off
Adjust water jet
Connect detergent bottle
Clean nozzle
Clean the water filter
Transport
Storage
Selecting Accessories
Starting
For Your Safety
Warning! Switch off, remove plug from mains
before adjusting, cleaning or if cable is cut, da-
maged or entangled.
The operating voltage is 230 V AC, 50 Hz (for non-EU coun-
tries 220 V, 240 V as applicable). Only use approved extensi-
on cables. Contact your Bosch Service Centre for details.
If you want to use an extension cable when operating your
high pressure washer, only the following cable dimensions
should be used:
2
- 1.5 mm – max length 20 m
2
- 2.5 mm – max length 50 m
Note: If an extension cable is used it must be earthed and con-
nected through the plug to the earth cable of your supply net-
work in accordance with prescribed safety regulations.
If in doubt contact a qualified electrician or the nearest Bosch
Service Centre.
WARNING! Inadequate extension cables can
be dangerous. Extension cable, plug and so-
cket must be of watertight construction and in-
tended for outdoor use.
Cable connections should be kept dry and off the ground.
For increased electrical safety to use a Residual Current De-
vice (RCD) with a tripping current of not more than 30 mA. Al-
ways check your RCD every time you use it.
If the supply cord is damaged, it must be replaced by a Bosch
Service Centre.
For products not sold in GB:
WARNING: For your safety, it is required that the plug at-
tached to the machine is connected with the extension cord.
The coupling of the extension cord must be protected against
Bosch Power Tools
splash water, be made of rubber or coated with rubber. The
extension cord must be used with a cable strain relief.
Figure Page
Products sold in GB only: Your product is fitted with a
BS 1363/A approved electric plug with internal fuse (ASTA
1 53
approved to BS 1362).
53
If the plug is not suitable for your socket outlets, it should be
cut off and an appropriate plug fitted in its place by an autho-
3 54
rised customer service agent. The replacement plug should
3 54
have the same fuse rating as the original plug.
The severed plug must be disposed of to avoid a possible
shock hazard and should never be inserted into a mains so-
4 55
cket elsewhere.
5 55
Products sold in AUS and NZ only: Use a residual current de-
6 56
vice (RCD) with a rated residual current of 30 mA or less.
7 56
Operation
8 57
9 57
 To prevent damage to the appliance, do not allow it to
10 58
operate dry.
11 58
Starting
11 59
Attach water supply hose (not supplied) to the mains water
12 60
supply and machine.
Connect the product to the mains supply ensuring that the
mains switch is in the off position.
Open water tap.
Press the safety lock (back button on the gun handle) to re-
lease the trigger. Fully press the trigger until there is a cons-
tant flow of water to clear the air from the machine and water
supply hose. Release trigger. Press the safety lock (front but-
ton on the gun handle).
Turn button on main switch. Point the power gun downwards.
Press the trigger safety lock to release the trigger. Fully press
the trigger.
Autostop function
The machine is designed to switch off the motor when the trig-
ger is released on the gun.
Working Advice
General
Ensure that the pressure washer is on level ground.
Do not overreach with the high pressure hose or move the
pressure washer by pulling the hose, this could cause the ma-
chine to become unstable and fall over.
Do not kink or drive a motor vehicle over the high pressure ho-
se. Do not expose the high pressure hose to sharp edges or
corners.
Never use a roto nozzle to clean motor vehicles.
Working advice for cleaning with detergents
 Only use cleaning agents suitable specifically for high
pressure washers.
We recommend that you use detergent sparingly for the sake
of the environment. Observe the recommended dilution on
the detergent label.
English | 7
F 016 L81 121 | (18.2.15)