Matrix 25 Parameters; Codabar Parameters - Wasp WWS800 User Manual

• Fixed Code Length Qualification
Select Fixed Length Qualification
Fixed Length 1 *
Programming Instructions: (1) Read the label. (2) Program the desired length
by reading Decimal Digits on page 53. (3) Read the "Validate" label (also on
page 53) to complete this setting.

Matrix 25 Parameters

Matrix 25 Parameters Matrix 25 Parameters Matrix 25 Parameters
• Start / Stop Selection
Industrial 25
< Matrix 25 >
• Checksum Verification
Enable
• Checksum Transmission
< Enable >
Fixed Length 2 *
Interleave 25
< Disable >
Disable
Update
• Max / Min Code Length Qualification
• Fixed Code Length Qualification
Programming Instructions: (1) Read the label. (2) Program the desired length by
reading Decimal Digits on page 53. (3) Read the "Validate" label (also on page
53) to complete this setting.

Codabar Parameters

Codabar Parameters Codabar Parameters Codabar Parameters
• CLSI Conversion
• Start / Stop Transmission
29 30
Select Max / Min Length Qualification
Max Length *
Select Fixed Length Qualification
Fixed Length 1 *
Enable
Enable
Enter Setup
Min Length *
Fixed Length 2 *
< Disable >
< Disable >