NETGEAR 700 Series Software User's Manual page 113

Name
Use the command to give a name to the switch. This is done to make the switch easier to
name
identify.
Syntax
FSM726(config)# snmp-server name <switch name>
Where
= the name you wish to give to the switch
<switch name>
Host
The command is used to specify hosts to receive SNMP notifications.
host
Syntax
FSM726(config)# snmp-server host <host name> <host IP address> <community string>
Where
= the name of the host that is to receive SNMP notifications.
<host name>
<host IP address>
<community string>
Host Authorization
The
host-authorization
Syntax
FSM726(config)# snmp-server host-authorization
Trap
The command enables SNMP trap. s IP is not in the SNMP host table.
trap
Syntax
FSM726(config)# snmp-server trap
Command Line Interface
700 Series Managed Switch User's Guide for Software v2.1
= The IP address of the host specified
= the community which the host belongs to
command enables SNMP host authorization.
SM-10004-02
6-23