Configure; Diffserv - NETGEAR 700 Series Software User's Manual

Managed switch
Table of Contents

Advertisement

700 Series Managed Switch User's Guide for Software v2.1
= The VLAN ID. Adding the VLAN ID to the show vlan command displays
<VLAN index #>
the port that belongs to that particular VLAN. For example, show vlan 1 displays the ports that
belong to VLAN 1.
An example of the display output is shown below:.
Untagged port members: 4,5,7,11-15,19-23
Tagged port members: none
COS-PVID
The
show vlan cos-pvid
Syntax
FSM726# show vlan cos-pvid
An example of the display output is shown below:
Port
PVID Priority
------------------------
1:1
1
Normal
1:2
1
Normal
1:3
1
Normal
1:4
1
Normal
1:5
1
Normal

Configure

Entering the command
you're in configuration mode, the prompt changes to
FSM726(config)#
It is in this mode where the vast majority of configuration is performed. To exit the configuration
mode and return to root prompt, use the exit command.

DiffServ

DiffServ divides traffic into one of 64 classes using the packet's DSCP value. This allows for
greater differentiation of traffic priority than port-based traffic prioritization.
Syntax
6-12
displays the PVIDs and the CoS settings of each port.
at the root prompt takes you into configuration mode. When
configure
SM-10004-02
Command Line Interface

Advertisement

Table of Contents
loading

Table of Contents