Table of Contents
Advertisement
FSM726(config)# diffserv <DSCP> <priority>
Where
= The DSCP value, which ranges from 0-63
<DSCP>
= The priority associated with the defined DSCP value. The available options are
<Priority>
normal and high
For example, suppose you want to set DSCP 33 to high, the command to do so would be:
FSM726(config)# diffserv 33 high
Exit
The
command takes you out of the CLI mode by one level. For example, when you are in
exit
configuration mode, and the prompt looks like
prompt, you will exit the configuration mode and be taken back to the root level, where the prompt
.
looks like
When you enter the
FSM726#
Main Menu of the switch.
Syntax
FSM726(config)# exit
Interface
The
command allows you to configure each network interface of the switch. Items
interface
such as the speed, duplex, and negotiation are configured in this mode. The command to enter the
interface mode is
Syntax
FSM726(config)# interface ethernet <x/y>
Where
=
x is the stack number, and y is the port number, which ranges from 1-26. Since FSM726
<x/y>
is not stackable, the value of x is always 1.
For example, suppose you want to configure port 8 on the switch, the command to do so would be:
FSM726(config)# interface ethernet 1/8
Command Line Interface
700 Series Managed Switch User's Guide for Software v2.1
FSM726(config)#
command at the root level, you will return to the
exit
SM-10004-02
.
By entering
at the
exit
6-13
Advertisement
Table of Contents
