Denwa Communications DW-V-AXT-ANDROID User Manual page 41

Password
Lock
StandBy
DTMF
LED
RTSP
Web Relay

Display number: The default is 4.

Tamper: The default is off. Users can enable it for safety.
Note: Please root the device after you setup .
Users can configure project key and public key with this
function.

Public Enable: the default status is on.

Public Key：The default key is 33333333, users can
reset a new public key. The key must be 8digit number.

Project Key: It is used to enter the project setting, the
default project key is 9999.

User Setting Key: The password which is used to enter
the project setting.
To setup the corresponding lock parameter.

Lock Type: There are two types: power on and power
off.

Lock Delay: The range is 0sec to 10sec. The default
delay time is 0sec.

Lock Magnet Type: Different lock with different Magnet
types. Users can setup it as Open or Close. The default
status is Disable.

Lock Magnet Delay: The default is 20sec. The maximum
is 120sec.
It will show the corresponding status when the device is idle.

StandBy Mode: There are 3- type modes: Image、Black
and None. The default is Image.

StandBy Time: The default is 60sec. The maximum is
180sec.
Users can setup DTMF function to unlock via pressing
the corresponding code number. It can setup code1 and
code2 in the same time.
To setup LED parameters

LED Type: The default status is off

Threshold: The current intensity of the environment.
Enable RTSP for Onvif function.
Connect external web relay.
Type: Select 2N WebRelay to enable this function. And
DW-V-AXT-ANDROID
the
IP Address: Setup web relay IP address.
UserName: Setup web relay user name.
Password: Setup web relay password.
relay will be disabled.