Pioneer DV-37 Service Manual page 87

LB, RL and RL/RD Types
CONTROL DIGITAL OUT
OUT IN
OPT
COAX
7 8 9
1
COMPONENT VIDEO OUT switch
You only need to set this switch if you're using an NTSC TV/
monitor connected via the component video outputs of this
player. This player can output NTSC video as a standard
interlaced signal (the 525i(480i) setting), or as a non-interlaced,
or progressive scan signal (the 525p(480p) setting). Generally,
however, you should leave it set to MENU SELECT, which
makes this setting switchable from the on-screen Setup menu.
Switch manually if you have chosen a setting from the Setup
menu that is incompatible with your television/monitor and
therefore can't see any picture.
2
COMPONENT VIDEO OUT jacks
(Interlace/Progressive-scan)
If your TV or monitor has component video inputs, you can
produce a higher quality picture on your TV or monitor by
connecting to the component video outputs on this unit.
3
D2 jack
(Interlace/Progressive-scan)
If your TV or monitor has D video input, you can produce a
higher quality picture on your TV or monitor by connecting to
the D2 video output on this unit.
4
S-VIDEO OUT jacks
If your TV or monitor has an S-video input, clear picture
reproduction is possible by connecting the player to your TV or
monitor via the S-Video jack.
You can switch between [S1] and [S2] S-video output from the
Setup menu.
5
VIDEO OUT jacks
Connect to the video input on a TV or monitor or AV amplifier or
receiver with video input capability.
DV-37, DV-S77, DV-S737, DV-737, DV-737-K
1 2
Y P P
B
525i 525p
(480i) (480p)
MENU
SELECT
COMPONENT VIDEO OUT
AUDIO OUT
R
TV SYSTEM
2 2
NTSC
PAL
AUTO
1 1
0 -
3 4 5
R
1 2 1 2
D2
S-VIDEO OUT VIDEO OUT
L
6
AC IN power cord connection terminal
Use to connect the power cord to the wall outlet.
7
CONTROL IN/OUT jacks
Use to connect this player to another component bearing the
Pioneer Î mark. This lets you control this unit as though it
were a component in a system. Player operations are then
performed by pointing the remote control at the component that
the player is connect to.
8
DIGITAL OUT jack (optical (OPT))
Use to output the digital audio signal recorded on discs. You
can output the digital signal via either optical output jack to an
AV amplifier or receiver.
9
DIGITAL OUT jack (coaxial (COAX))
Use to output the digital audio signal recorded on discs. You
can output the digital signal via either coaxial output jack to an
AV amplifier or receiver.
0
TV SYSTEM switch
Use to change the TV signal mode to either PAL or NTSC
according to the type of TV and disc to be used. When the
switch is in the AUTO position, the player outputs the format on
the disc as is.
-
AUDIO OUT jacks
Use to output two-channel audio (analog) to the audio stereo
inputs on a TV or stereo amplifier. If you are connecting to a
receiver that has both digital and analog input jacks for DVD
player connection, it may be beneficial to make both
connections.
6
AC IN
87