This chapter gives information about troubleshooting your Double 108 Mbps Wireless Firewall
Router WGU624. After each problem description, instructions are provided to help you diagnose
and solve the problem.
Note: Product updates are available on the NETGEAR, Inc. Web site at
http://kbserver.netgear.com/products/WGU624.asp.
Basic Functioning
After you turn on power to the router, the following sequence of events should occur:
When power is first applied, verify that the Power LED is on.
1.
After approximately 10 seconds, verify that:
2.
The Local port LEDs are lit for any local ports that are connected.
a.
If a port's LED is lit, a link has been established to the connected device. If a LAN port is
connected to a 100 Mbps device, verify that the port's LED is green. If the port is 10
Mbps, the LED will be amber.
The Wireless A port LED is lit.
b.
The Wireless G port LED is lit.
c.
The Internet port LED is lit.
d.
If any of these conditions does not occur, refer to the appropriate following section.
Troubleshooting
M-10153-01
Chapter 8
Troubleshooting
8-1