NETGEAR WGU624 Reference Manual page 92

Reference Manual for the Double 108 Mbps Wireless Firewall Router WGU624
To add or edit a Static Route:
Click the Add button to open the Add/Edit menu, shown below.
1.
Figure 7-7. Static Route Add/Edit menu
Type a route name for this static route in the Route Name box under the table. (This is for
2.
identification purposes only.)
Select Private if you want to limit access to the LAN only. The static route will not be reported
3.
in RIP.
Select Active to make this route effective.
4.
Type the Destination IP Address of the final destination.
5.
Type the IP Subnet Mask for this destination. If the destination is a single host, type
6.
255.255.255.255.
Type the Gateway IP Address, which must be a router on the same LAN segment as the router.
7.
Type a number between 1 and 15 as the Metric value. This represents the number of routers
8.
between your network and the destination. Usually, a setting of 2 or 3 works, but if this is a
direct connection, set it to 1.
Click Apply to have the static route entered into the table.
9.
7-14
M-10153-01
Advanced Configuration