Basic Settings; Initial Settings; Setting The Clock; Hiding/Displaying The Clock - AEG KS7415001M User Manual

BASIC SETTINGS

Initial Settings

After your steam oven is first plugged in or after a power failure, the clock display will
flash to indicate that the time shown is not correct.
The oven will not operate until the clock and the water hardness are set.
To set the clock and the water hardness parameter value proceed as described in the
following chapters.

Setting the clock

To set the clock, proceed as follows:
• Select the Clock Symbol with the Parameter selection keys
oven is first plugged in or after a power failure). The hours start blinking.
• Set the hours with ''+'' and ''-''keys
• Confirm the selection with the Confirmation key
• Set the minutes with the ''+'' and ''-''keys
• Confirm the selection with the Confirmation key

Hiding/Displaying the Clock

• Select the Clock Symbol with the Parameter selection keys
• Press the Confirmation key
sure that you press first the confirmation key).
To show the clock again, repeat the described procedure again.
1 2 3
and the Cancel/Safety Block Key
1
188
12 30
4
4 .
.The minutes start blinking.
1
4 .
.
1
Basic Settings
5 6
(not necessary if your
3
3 . The hours start blinking.
at the same (make
6
10