Main Back Access; Terminal Block - Viking vdsc530t Service Manual

Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect electrical power to unit using power
switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure
correct earth ground and polarization. After servicing, reconnect power using power switch.

Main Back Access

To access the main back:
1. Remove 5/16" screws securing back guard.
Lift back guard up and out.
Back Guard
5/16" Screws
2. Remove 5/16" screws securing side cover and
main back cover.
Main Back Panel
Cover Plate
© 2010 Viking Preferred Service
Side Cover Panel
5/16" Screws
WARNING
3. Remove covers and repair/replace as
necessary.
4. Reverse procedure to reinstall.

Terminal Block

To access the terminal block:
1. Remove cover plate (see Main Back Access
section).
2. Mark wires and disconnect wiring and power
cord.
Terminal Block
3. Remove screws securing terminal block and
repair/replace block as necessary.
4. Reverse procedure to reinstall.
Screws
66