Service Diagnostics and Procedures–Disassembly
To avoid risk of electrical shock, personal injury, or death, disconnect gas supply and electrical power to unit
before servicing. Discharge capacitor through a resistor before attempting to service. Wires removed during
disassembly must be replaced on proper terminals to insure correct earth ground and polarization. After
servicing, reconnect electrical power and gas supply. Before placing appliance into operation, always check
for gas leaks with soapy water solution. DO NOT USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.
Door Lock Assembly
To access door latch assembly:
1.
Follow landing ledge steps 1-4 (see Landing
Ledge section, page 49).
2.
Remove 5/16" screws securing door lock
assembly and remove door lock assembly.
Screw
Screw
Door Lock
3.
Mark wires and disconnect.
4.
Repair/replace door lock assembly as needed.
5.
Reverse procedure to reinstall.
© 2010 Viking Preferred Service
WARNING
Door Switch
To access door switch:
1.
Follow landing ledge disassembly steps 1-4
(see Landing Ledge section, page 49).
2.
Remove two screws securing door switch.
Screw
3.
Mark wires and disconnect.
4.
Repair/replace door switch as needed.
5.
Reverse procedure to reinstall.
56