Installation Overview - LG LS091HSV3 Installation Manual

REFRIGERANT PIPING CONNECTIONS

Installation Overview

Installation
Single Zone Wall-Mounted systems are one-to-one systems. There
is a direct piping connection between the outdoor unit and the
indoor unit. Figure 41 Illustrates the basic pipe connections between
the outdoor and indoor unit. Refer back to this illustration as you
proceed with pipe connections. This illustration shows the indoor unit
being installed at a higher position than the outdoor unit. However,
should you install the outdoor unit at a higher position than the
indoor unit, the basic pipe connections should be the same.
Refer back to the tables within the "Connection Limitations"
section, on the previous page, for specific length limitations in con-
junction with outdoor unit and indoor unit positioning.
• As you proceed with the piping connections be sure to adhere to
pipe support spacing lengths as shown in Figure 42 below. Refer
back to "Pipe Supports" section for in-depth information regard-
ing using elbows, clamps and pipe supporting materials.
• Always adhere to local codes regarding piping and accurate
support spacing along the outdoor pipe line.
Figure 42: Pipe Support Lengths - Outdoors
Pipe
Clamps
A + B 12"–19"
38
A
B
Due to our policy of continuous product innovation, some specifications may change without notification.
©LG Electronics U.S.A., Inc., Englewood Cliffs, NJ. All rights reserved. "LG" is a registered trademark of LG Corp.
Figure 41: Installation and Piping Connection Overview
Installation Overview
Air Inlet
Air Outlet
Base Plate
Additional accessories/parts/tools that will be
needed for installation but are not provided by LG.
Installation plate
Sleeve
Bushing-Sleeve
Putty(Gum Type Sealant)
Bend the pipe as closely
on the wall as possible,
but be careful that it
doesn't break.
Vinyl tape (Wide)
• Apply after carrying out a
drainage test.
Saddl e
Gas side piping
Liquid side piping
Additional drain pipe
Vinyl tape (Narrow)
Drain Hose
Connecting cable
Tubing Cover