NETGEAR WG102 Reference Manual page 34

Reference Manual for the NETGEAR WG102 ProSafe 802.11g Wireless Access Point
Click the Wireless Settings link in the Setup section of the main menu to view the Wireless
b.
Settings menu.
Figure 3-5: Basic Wireless Settings menu
Configure the wireless interface for wireless access. See the online help or the
c.
Understanding Basic Wireless Settings
instructions.
Note: You must set the Country/Region. It may not be legal to operate the wireless access
point in a region other than one of those identified in this field.
Now that you have finished the setup steps, you are ready to deploy the WG102 in your
network. If needed, you can now reconfigure the computer you used in step 1 back to its
original TCP/IP settings.
3 D
EPLOY THE
Disconnect the WG102 and position it where you will deploy it. The best location is
a.
elevated, such as wall mounted or on the top of a cubicle, at the center of your wireless
coverage area, and within line of sight of all the mobile devices.
Lift the antenna on either side so that they are vertical.
b.
Note: Consult the antenna positioning and wireless mode configuration information in the
Advanced Configuration
Connect an Ethernet cable from your WG102 Access Point to a LAN port on your router,
c.
switch, or hub.
3-9
WG102 A
CCESS
chapter of the Reference Manual.
October 2004
topic of this Reference Manual for full
P
OINT
Basic Installation and Configuration